Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING casting mark is at the top 4 - 59 9. When installing, tighten until the packi ng surface contacts the seal surface of the filter ho lder, then tighte n it 3/4 of a turn. If the filter cartridge is tightened too fa r, the packing will be damaged and this will lead t o leakage of fuel . If the filter cartridge is too loose, fuel will als o leak from the packing, so always tighten the co When tightening with a filter wrenc h, be extremely careful not to dent or damage the 10. Check that the drain plug at the botto m of the water separator cup is tightened securely Tightening torque: 0.2 to 0.45 Nm (0. 11.

After replacing the fuel main filter cart ridge (at intervals of 1,000 hours), bleed air. For d etails, see "REPLACE FUEL MAIN FILTER CARTRIDGE (P AGE 4-65)". Do not add fuel to the fuel main filter cartridge, howe ver. 12. Start the engine, check that there is n o leakage of fuel from the filter seal surface or wa ter separator mo unting surface, then run for approximately 10 minutes at low idle. LUBRICATE CAB MOUNT PIN (LEFT AND RIGHT: 1 PLACE EACH) ase through the grease e that was pushed out. day when operating in easily, such as when 1. Stop the engine. 2. By using a grease pump, pump in gre fittings shown by arrows. 3.

After greasing, wipe off any old greas Perform the greasing operation every places where the grease flows out traveling through mud or water. Immediately after the engine is stopped, its parts and oil are still very hot, and may cause burn inju ry. Accordingly, wa it until they have cooled down before starting the work. case, the oil or plug may fly out. ure. If there is still pressure remaining inside the Loosen the plug slowly to release the press 1. Stop the machine so that the TOP ca and drain plug (P) is at the bottom. 2. Remove plug (G) and check that the oi of the plug hole. 3. If the oil level is too low, add oil throug oil overflows. 4.

Repeat the procedure in steps 1 - 3 an add oil to all the final drive cases (fron