Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN TRANSMISSION CASE WARNING OIL FILTER ELEMENT (PAGE 4-70) (P). Remove 2 drain plugs (P), drain the oil, then tighten the plug again. brake of oil oil any 4 - 68 I mmediately after the engin e is stopped, its parts and o il are still v ery hot, and may cause burn injury . Accordingly, wait unti hey have cooled down bef When removing the oil fille r cap, turn it slowly to releas e the inter R efill amount of oil:

115 liters (30.38 US gal) (including oil in the brake oil tank and each fil Perform the following item s at the same time in orde r to drain REPLACE TRANSMIS SION FILTER ELEMENT (PAGE 4 E 4-68) BRAKE CHANGE OIL IN TRAN CHANGE OIL IN BRAK SMISSION CASE (PAG E OIL TANK, REPLACE 1. Set the container to ca tch the oil directly under the drain REMARK When changing oil in the brake oil tank and replacing the b filte r element, perform step s 1 to 5 mentioned in "CHANGE O BRAKE OIL TANK, REPL (PAGE 4-70)".

ACE BRAKE OIL FILTER ELEM NOTICE Do not start up the engine wit hout the transmission being filled with the engine is started up while the transmission is empty or short of oi transmission hydraulic pump will suffer damage. 2. Before starting the en gine, add 90 liters (23.78 US gal) ). level will temporarily go above th (G), but this does not indicate through oil filler port (F When oil is added, the level on sight gauge 3. 4. abnormality. Start the engine and ru Add oil through oil filler n at low idle. port (F) until the oil level is betwee H and L marks on sigh t gauge (G).