Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION FILTER ELEMENT WARNING VALVE SIDE Prepare a filter wrench CASE, ADD OIL (PAGE 3-74)". 4 - 67 Immediately after the engine is sto pped, its parts and oil are still very hot, and may cause burn injury. Accordingly, wait unti they have cooled down before sta rting the work. urn it slowly to release the internal pressure, then remove it. When removing the oil filler cap, t 1. Set the container to catch the oil under the filter case. e filter head, drain the oil, then n filter cartridge (2) to the left to he seal surface of the new filter , then install it. m (5.5 to 6.5 kgm, 39.8 to 47.2 2. Remove drain plug (1) at th tighten the plug again.

By using a filter wrench, tur remove it. Clean the filter head, coat t 3. 4. cartridge thinly with clean oil Tightening torque: 54 to 64 N lbft) 5. Add oil. For details, see "CH BRAKE COOLING SIDE e cover (2). 1. Remove bolt (1), then remov 2. Set the container to catch th e oil directly under the drain plug (P). Remove drain plug (P), dra again. Take out the element, then removed parts. in the oil, then tighten the plug clean the inside of the case and install cover (2) with bolt (1). e "CHECK OIL LEVEL IN D OIL (PAGE 3-74)". bleeder screw (3), then insert a 3. 4. Install the new element, then 5. Add oil. For details, se TRANSMISSION CASE, AD 6. Remove the cap installed to vinyl hose.

Prepare a contain er with oil in it and insert the other end of the hose approx. 50 m m (2.0 in) below the surface of the oil. (Use any commercially a vailable vinyl hose.) der screw (3) approx. 3/4 turns, 7. Start the engine, loosen blee and keep the engine running at idling until fewer bubbles come out from the vinyl hose. perly, then install the cap. e transmission case is up to the 8. Tighten bleeder screw (3) pro 9. Check that the oil level in th specified level. Add oil if the level is low. 10.