. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER HM METHOD OF USING ACCURATELY 6 - 7 1. The payload meter uses the signal from t he suspension pressure sensor to measure the load . Adjust th e length of t he suspension cylinder periodically t o the proper range. For details, consult your Koma tsu distribut 2. PERFORMING CALIBRATION g cases. into the jobsite d (when the machine weight has changed) as been adjusted passed traight road of approx. 120 m (393 ft 8 in) with no uneven places.
Perform calibration travel in the followin When the machine has been brought When the machine has been modifie When the suspension cylinder gas h When the fixed periodic interval has Perform the calibration travel on a flat, s traight road of approx. 120 m (393 ft 8 in) with no u neven plac If t he measurement is carried out on a ro ad that is not flat or not straight, it will be impossible t o achieve a ccurate measurement. 3. METHOD USING TRAVEL MODE cted When method using travel mode is sele The accuracy varies according to the as possible.
This will make it pos measurements, perform maintenanc The accuracy varies according to t accurate the measurement becomes 8 km/h (5.0 MPH) and on a grade o minimum distance is 100 m (328 ft 1 When method using travel mode is sele The accuracy varies according to the condition of the road. Perform the calibration on a road that i s as flat as possible. This will make it pos sible to perform accurate measurement. To make highly precise e of the road surface first. he distance travelled. The longer the distance travelled, the more precise measurements, perform maintenanc The accuracy varies according to t accurate the measurement becomes .
Perform the measurement only when traveling at a speed of at least 8 km/h (5.0 MPH) and on a grade o f less than 5 deg. Even on roads fulfilling the above conditions, the in). minimum distance is 100 m (328 ft 1 4. METHOD USING DUMPING MODE elected rea When method using dumping mode is s Perform where working range is flat a Perform the work in a place where the will be poor. Do not put the blocks in strong conta value will be higher than the actual v When dumping, use the parking brak Stop with the brake and wait for the p To obtain an accurate value, apply th for 3 to 5 seconds before dumping.
When method using dumping mode is s Perform where working range is flat a Perform the work in a place where the grade is within ±5 deg. If the grade is more than ±5 deg., the ac curacy will be poor. ct with the tires. If there is strong contact, the payload measurement alue. e. Release the foot brake or retarder brake. itching of the machine to stop before raising the dump body. Do not put the blocks in strong conta value will be higher than the actual v When dumping, use the parking brak Stop with the brake and wait for the p itching of the machine to stop before raising the du To obtain an accurate value, apply th e parking brake and release the foot brake or retarde r brake.
Th en wait for 3 to 5 seconds before dumping.