Komatsu — OPERATION OF SWITCHES

. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER HM METHOD OF PERFORMING CALIBRATION (METHOD OF OPERATION) 1. Move the CAL/CLR switch (1) pressed for at least 2 seconds. (The letters CAL flash) 2. Press CAL/CLR switch (1) again. (Letters CAL light up.) 3. Shift the gear shift lever to 2, depress the accelerator pedal 5. Stop the machine slowly. After stopping the machine completely, return the gearshift lever to N . Use the 6 - 21 hift lever to N position a nd keep C n a straight line. When th e travel spe .6 MPH), the elapsed time is displaye 4. The present pay load measurement value is displayed 30 seconds a fter performing calibr Release the foot brake or retarder bra 6.

If the dump body is empty, the measureme ntvalue for t he payload is measured a s approx. 0 .0 tons. If m ore than ±1 tons is displa yed for the payload, perfo rm calibrati on travel again . 7. Press the MOD E switch. The display cha nges to the normal opera tion display NOTICE Perform the calibrat ion on a flat road surface wi th no uneven places. The fl atter the road surface is, the more acc urate the measurement beco mes. ine. (Distance: Approx. 120 m (393 ft 8 in)) rm the calibration accurately. If calibration is not carried out accurately, there will be an error in the payload, so the measurement will not be correct. ever to 2 and depress the accelerator pedal fully.

Do not let the accelerator pedal back. Travel in a straight l ine. (Distance: Approx. 120 m (393 ft 8 in) Be careful to perfo rm the calibration accurately . If calibrati measurement of the payload, so the measureme nt will not be Shift the gear shift l ever to 2 and depress the acc elerator ped al fully. Do not let the accelerato r pedal The calibration data are saved to the internal RAM . After calibr ation is being ca rried out, eve n if t he powe r is turned off , the data are retained. If it is desired to sto p the calibration during the ca libration ope ration, press the MODE switc h while the l etters CAL ar e flashing in step 1.

The displ ay will change from CAL to th e normal dis play. If an error occurs on the machine, depending on t he error, it m ay be impossible to perform c alibration. For details, se e Section "ABNORMALITY AN D WARNING DISPLAY (ERRO R CODE) (P AGE 6-32)"