Komatsu — CONTROL LEVERS AND PEDALS

. OPERATION EXPLANATION OF COMPONENTS GEAR SHIFT LEVER The gear range can be selected with this lever (3) to match the travel conditions. Position R2: 3 - 42 ACCELERATO This pedal (2) is used to adju st the e It can be oper ated freely between the engine low idle position and the full throttle Position D: This is used when traveling normally. When this position is used, ormally ition is used, the transmiss ion is set automatical ly between the 2nd torque converter driv e and 6th gear accordi ng to the travel speed. While the dump bod y is raised, however, th e transmission i s fixed to the 2nd gear and is not changed. Keep th e dump body lo wered during travel.

The m aximum travel speed in this position is 58.5 km/h (36.4 MPH). REMARK In conformity with the EU safe ty rule ( EN474-6 5.1.3), the gear shift lever is restric ted to the 2nd s peed a nd cannot be sh ifted in the D position, whe n the machine i s runnin g while the dum p body is not fully lowered t o its seat. Position R1: This is used w hen traveling in revers e. When this po sition is used , the transmission is fixed in R1 and the trav el is carried out in t orque converte r drive o r direct drive ac cording to the travel speed. The maxim um travel speed in this position is 7.4 km/h (4.6 MPH ). This is used w hen traveling in revers e.

When this po sition is used , the transmission is fixed in R2 and the trav el is carried out in t orque converte r drive o r direct drive ac cording to the travel speed. The maxim um travel speed in this position is 17. 5 km/h (10.9 M PH). The machine cannot travel in reverse while the dump body is raised. Lower the dump body a nd set the dump l ever in "FLOAT" p osition, and the n set it i n "R1" or "R2" p