. OPERATION EXPLANATION OF COMPONENTS Max. speed [km/h (MPH)] 17.5 (10.9) 7.4 (4.6) 58.5 (36.4) 39.6 (24.6) 26.1 (16.2) 17.1 (10.6) 11.1 (6.9) 7.3 (4.5) When operating the shift lever, be sure to set it in position securely. If the lever is not placed in position properly, the shift position display on the panel may go out and the Transmission system caution lamp may light up. Before shifting between forward and reverse, stop the machine completely and then run the engine at low idle. When starting the engine, if the gear shift lever is not at N (neutral) position, the engine will not start.
When the starting switch is turned from OFF position to ON position, if the gear shift lever is not at N (neutral) position, the shift lever position pilot lamp flashes, the centralized warning lamp lights up, and the alarm buzzer sounds. When this happens, if the gear shift lever is returned to N (neutral) position, the lamps will go out and the buzzer will stop. When the parking brake is applied, if the gear shift lever is not at N (Neutral) position, the centralized warning lamp will light up and the alarm buzzer will sound.
If the gear shift lever is set to any position other than N (neutral) when the dump lever is at a position other than FLOAT or the body is still raised, the centralized warning lamp will light up and the alarm buzzer will sound. The gear shift lever must not be returned to N (neutral) position while traveling. Release the accelerator pedal and run the engine at low idle when moving the gear shift lever from N (neutral) position to the forward or reverse position. 3 - 43 5 - 1 p osition These positions are u sed in places where it is difficult to tr avel at h igh s peed, o r when traveling on soft ground, or when startin g the machin e off o n a s lope when it is loaded .
They a re also used when g oing downhill if i t is needed to use the br akin g force o f the engin While the du mp body is r aised, the t ransmission is fixed t o the 1st gear and is not changed . Keep the dump body lowered during tr avel REMARK In conformity wit h the EU safet y rule (EN474-6 5.1.3), the gear shif t lever is restricted t o the 1st speed and cannot be shifted if it is a nywher e between 1 to 5 positions , when the machine is running whil e the dump body is not fully lowered to it s se The spee d ranges for each p ositi on ar e as f ollows.
Position Speed range R2 R2nd torque converter - direct R1 R1st torque converter - direct D 2nd torque converter - 6th direct 5 1st torque converter - 5th direct 4 1st torque converter - 4th direct 3 1st torque converter - 3rd direct 2 1st torque converter - 2nd direct 1 1st torque converter - 1st direct