Komatsu — CHANGE THE FUEL FILTER

MAINTENANCE CHANGE THE FUEL FILTER Replace the filter element after the engine has cooled down from 40° to 45 ° C (104° to 113 ° F). Performing these opera- tions may cause fuel to spill. Clean the spilled fuel immedi- ately to prevent any risk of slipping or fire. Oils, filters, coolant, and the battery are considered special waste and must be collected and disposed of according to all antipollu- tion regulations. Open the engine hood to access the fuel filter and fuel pump. 1. Clean the external surfaces of the filter. 2. Unscrew and remove old filter (1) with the special wrench provided. 3. Clean inside of the head (2). 4. Lubricate the gasket of new filter and tighten thoroughly. 5.

Give it another half turn by hand. 6. After filling the tank, bleed the fuel supply circuit. A. Turn ignition switch to ON position. B. Loosen the filter drain screw (3), using a 12 mm wrench. C. Completely unscrew the fuel pump (5) and knob (4). D. Operate knob (4) until fuel without air bubbles flows out of the filter head. Tighten the drain screw (3). E. Press the knob (4) and tighten it completely. F. Start the engine. # If fuel does not flow after operating the fuel pump lever, rotate the drive shaft one turn. # Do not let the starter run for more than 15 seconds. Wait at least 15 seconds before repeating the starting procedure.

# If the engine starts and then stops or hesitates, check for any air in the system. If so, check the fuel filter, water separator, and fuel pump for leaks. # If the machine runs out of fuel, bleed the fuel system after refueling. 3-50 WB140PS-2N WB150PS-2N