Mack Trucks — Mack TerraPro LEU Series Operation Manual

60 INSTRUMENTS AND CONTROLS 9. Air Pressure Gauge Indicates the air pressure in the air brake system(s). The normal operating air pressure is between 759 kPa (110 psi) and 897 kPa (130 psi) in both air brake systems. If pressure drops below 75 psi (±5 psi) in either system, the warning buzzer and warning light will go on. Determine the cause of failure before proceeding. Primary air pressure is supplied to the rear brakes and is indicated by the green pointer on the gauge. Secondary air pressure is supplied to the steering axle brakes and indicated by the orange pointer. 10. Parking Brake Valve Yellow diamond-shaped knob. Pull to apply. Push to release. Applies parking brakes. 11.

Transmission Oil Temperature Gauge Indicates the temperature of the automatic transmission oil. The normal operating range is between 71°C and 93°C (160°F and 200°F). If the transmission oil temperature reaches 121°C (250°F), operation in the higher gears will be inhibited. If the transmission overheats during normal operation, stop the vehicle and check the transmission oil level. If both the transmission oil temperature gauge and the engine coolant temperature gauge indicate a high temperature, check the cooling system. If the cooling system appears to be functioning properly, shift the transmission into Neutral, set the parking brakes, and run the engine between 1200 and 1500 rpm.

The engine and transmission should cool sufficiently within two to three minutes. If the temperature does not drop to operating range, the condition must be investigated and corrected before continuing operation. 12. Voltmeter — Indicates the surface charge of the battery with the engine NOT running (and the ignition ON). Indicates the condition of charging system with the engine running. The voltmeter can be useful as a diagnostic tool. During cranking, the reading should not drop below 10 volts. Lower readings may indicate corroded connections at the cranking motor or battery terminals, or discharged or defective batteries. 13.

Mode Button Using this button will display diagnostic trouble code information and trip distance in the odometer. When you press and hold down this button, the display will go through a gauge self test. After the self test is complete, diagnostic trouble code information will be displayed, by MID, in the speedometer/odometer screen. When the first MID is displayed, push the Mode button again to display the 1st diagnostic trouble code for this MID. At the end of the diagnostic trouble code list for each MID, "CLEAR" will be displayed. You have the option here to clear the codes for this MID. If you choose to do so, press and hold the Mode button.

Once the codes are cleared for this MID, the next MID will be displayed. By pressing this button once (NOT holding it down), information for Trip 1 distance will be displayed. Press and hold the Mode button to clear Trip 1 information. By pressing this button twice, information for Trip 2 distance will be displayed. Press and hold the Mode button to clear Trip 2 information.