Komatsu — DISASSEMBLY

DISASSEMBLY AND ASSEMBLY SWING MOTOR 12 7. Remove spring (10) and center ring (11). 8. Using tool S14 , remove seven mounting screws, then remove retainer (12). 9. Remove center shaft (13) and seven pistons (14). 10. Using tool S24 , pump in air through port B and remove brake pis- ton (15). Air pressure .......................................................... 2 kgm/cmІ # Be careful that the air pressure is not too high or the brake piston will fly out. 11. Remove o-ring (16) from piston. 12. Remove plates (17) and discs (18). 13. Remove plates (19).

# Plates (17) .......................................................................................3 # Plates (19) .......................................................................................2 # Discs (18) ........................................................................................3 14. Remove case from tool S13 and turn over. Remove snap ring (20), then remove cover (21). # Put a screwdriver in contact with portion a and remove cover. 15. Remove oil seal (22) from cover (21). 16. Remove snap ring (23), then remove two spacers (24). 30-4 PC300LL-6