Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY SWING MOTOR 12 17. Set case to press and remove shaft (25) from case (26). 18. Remove bearing (27) from shaft (28). 19. Remove bearing inner race (29) from case. Remove bearing outer race (30). Remove seat (31) and belleville spring (32). Remove main bearing outer race (33). ASSEMBLY G Using chromium oxide, remove all the lapping powder from the places that have been lapped. Clean all parts, remove all burrs and check for dirt or damage. Coat the rotating parts and sliding sur- faces of all parts with engine oil before installing. 1. Using push tool B , press outer race (33) into case. 2. Using tool S16 , press bearing (27) onto shaft.

# Press until the end face of the inner race is in tight contact with the shaft. # Press load .........................................................................8 to 39 kN 3. Set shaft (25) to block C , then set case (26) in position. PC300LL-6 30-5