Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY SWING MOTOR 12 4. Install belleville spring (32) and seat (31). # Install belleville spring in the direction shown in ( a ). 5. Using tool S17 , install outer race (30). 6. Using tool S18 , press bearing (29). During the press operation, rotate case (26) and check that the bearing rotates smoothly. Press until seat (31) is in tight contact with case (26). # Bearing press load............................................................4 to 20 kN 7. Measure clearance a between bottom face of snap ring (23) and top face of bearing inner race, then select two spacers (24) equivalent to clearance a from table below. Spacer (24) Part No.

Thickness 706-77-42440 2.3 706-77 42450 2.5 706-77-42460 2.7 Unit: mm Standard assembled thickness of spacers ...................5.1 mm 30-6 PC300LL-6