DISASSEMBLY AND ASSEMBLY SWING MOTOR 12 8. After assembling spacers (24), install snap ring (23). # Check that the snap ring is fitted securely in the snap ring groove. 9. Assemble tool S19 to case (26), then push out drive shaft under load given below until end face of bearing inner race (29) is in tight contact with spacer (24) and snap ring (23). # Pushing out load...............................................................4 to 16 kN 10. After bringing bearing into tight contact, apply a load of 22 kN and check that spacer (24) cannot be rotated by hand and that spacer is in tight contact. 11. Check clearance between case (26) and seat (31) as follows: A.
Using tool S19 , apply a load of 5 to 22 kN to tip of drive shaft, measure movement of drive shaft and check that it is within specified value. Drive shaft movement ..................................... 0.1 to 0.4 mm B. If movement of drive shaft is not within specified value, adjust spacer as follows: G If clearance is less than 0.1 mm: replace spacer with 706-77- 42440 and install snap ring. G If clearance is more than 0.4 mm: replace spacer with 706-77- 42460 and install snap ring. G Repeat steps to measure movement of drive shaft and check that clearance is within range of 0.1 to 0.4 mm. PC300LL-6 30-7