Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY SWING MOTOR 12 15. Install o-ring (16) to piston. 16. Install brake piston (15). 17. Set seven pistons (14) and center shaft in position. Using tool S14 , tighten 7 retainer mounting screws. # Replace the mounting screws with new parts. Retainer screw ..................................Thread tightener [LT-2] 1st step [tighten temporarily] ...........................Max 0.98 N•m 2nd step ............................................................3.9 to 5.9 N•m 3rd step............................................................13.2 ± 1.5 N•m # Remove all oil and grease from the threads [male and female] and dry completely. # Order for tightening; !

- " - # - - % - & - ' . # After tightening, wipe off any adhesive that has been squeezed out. # Check that the large ball of piston (14) and center shaft (13) move smoothly. 18. Using dial gauge E , measure play of piston (14) in axial direction. Play of piston ...................................................... Max 0.25 mm 19. Position housing (6) on tool S13 together with tool S22 , then adjust angle so that valve plate mounting surface is horizontal. Install valve plate (18). PC300LL-6 30-9