Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY SWING MOTOR 12 20. Assemble cylinder block (9) to housing (6). Assemble spring (10) and center ring (11) to cylinder block. 21. Install six springs (7) to housing. Position dowel pin (34) to hole. 22. Using tool S23 , knock in the dowel pin so that the dimension a is the standard value. Standard value a .................................................. 8 to 10 mm 23. Assemble tapered end A to the hole in the housing. Be careful not to damage the dowel pin and the brake piston. 24. Raise motor case, align with housing and lower slowly, align seven center shaft pistons with holes in cylinder block, then install hous- ing (6). Case surface.............................

Gasket sealant [LG5 or LG7] # Align the dowel pins with the holes in the motor case exactly when installing. Cover mounting bolt......................................277 ± 32 N•m 25. Position swing motor onto tool S13 . Install sleeves (4), springs (3) and covers (2). Cover mounting bolt........................................110 ± 2 N•m 30-10 PC300LL-6