DISASSEMBLY AND ASSEMBLY SWING MOTOR 12 26. Check drive shaft rotation torque as follows: A. Using tool S15 , apply pressure through port B to release brake. Brake release pressure ............................... at least 20 kg/cmІ B. Set tool S20 in position and check rotating torque. # When checking the rotating torque, check that the shaft rotates smoothly without any hesitation or rough spots. Variation .........................................................Max 1.5 N•m Rotating torque...........................................5.9 to 15.2 N•m # If it is not within the specified value, adjust again. PC300LL-6 30-11