Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY SWING MACHINERY 12 SWING MACHINERY REMOVAL WARNING! Release the remaining pressure in the hydraulic circuit. For details, see TEST- ING AND ADJUSTING WARNING! Loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. # Fit blind plugs in the disconnected hoses and tubes to prevent oil from flowing out. 1. Remove step on top of control valve. 2. Disconnect suction hose (1), swing hose (2), drain hoses (3) and (4), and swing holding brake hose (5) connected to swing motor. 3. Disconnect arm hose (6) and let it hang down. 4. Disconnect left travel hose (7) at control valve end and move towards boom. # Secure it to the boom with rope. 5.

Disconnect bucket cylinder hose (8) at control valve end. 6. Lift off swing motor (9). Swing motor ............................................................. 110 kg 7. Lift off swing machinery (10). Swing machinery...................................................... 550 kg # After removing the right travel hose clamp mounting bracket, remove the swing machinery. INSTALLATION G Carry out installation in the reverse order of removal. Swing machinery case bolt..........................927 ± 103 N•m 30-12 PC300LL-6