DISASSEMBLY AND ASSEMBLY SWING MACHINERY 12 10. Disassemble # 2 carrier as follows: A. Push in pin (18), and knock out shaft (19) from carrier (17). # After removing the shaft, remove pin (18). B. Remove thrust washer (20), gear (21), bearing (22), and thrust washer (23). 11. Remove bolt (24), then remove holder (25). Remove gear (26). 12. Turn over case and pinion, then remove mounting bolts (28) from cover (27). 13. Turn over case and pinion (29), and set on press stand. Then, using push tool A , remove pinion shaft (30) with press. # Set a wooden block under the press and be careful not to damage the pinion shaft when removing it. PC300LL-6 30-15