DISASSEMBLY AND ASSEMBLY SWING MACHINERY 12 12. Install #2 sun gear (15) to #2 carrier, then install collar (14) and thrust washer (13). 13. Raise ring gear (12) and install. # Align with the drain hole and assemble. Ring gear and case surface......................Gasket sealant [LG-6] # There are the remains of the staking when the pin is inserted at the end face of hole h at the side of the carrier, so remove the staked metal from the inside diameter of the hole before starting to assem- ble. 14. Assemble bearing (10) to gear (9), fit top and bottom thrust wash- ers (8) and (11) and set gear to carrier (7). 15.
Align position of pin holes of shaft and carrier, then tap with a plas- tic hammer to install shaft (6). # When installing the shaft, rotate the planetary gear, and be careful not to damage the thrust washer. 16. Insert pin (5). # After inserting the pin, stake the pin portion of the carrier. # After assembling carrier, check that gear (9) rotates smoothly. PC300LL-6 30-19