Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY SWING MACHINERY 12 # There are the remains of the staking when the pin is inserted at the end face of hole h at the side of the carrier, so remove the staked metal from the inside diameter of the hole before starting to assem- ble. 7. Assemble bearing (22) to gear (21), fit top and bottom thrust wash- ers (23) and (20) and set gear to carrier (17). 8. Align with position of pin holes of shaft and carrier, then tap with a plastic hammer to install shaft (19). # When installing the shaft, rotate the planetary gear, and be careful not to damage the thrust washer. 9. Insert pin (18). # After inserting the pin, stake the pin portion of the carrier.

# After assembling the carrier, check that gear (21) rotates smoothly. 10. Raise #2 carrier (17) and install. # Align the position so that the tip of the gear shaft enters at four places, then install. 11. Assemble thrust washer (16). 30-18 PC300LL-6