DISASSEMBLY AND ASSEMBLY SWING MACHINERY 12 3. Fit cover (27) to case (35), and tighten mounting bolts (28). # Be careful not to let the gasket sealant [LG-6] get on the oil seal lip when press fitting. Cover mounting surface..........................Gasket sealant [LG-6] Mounting bolt........................................................66 ± 7 N•m Lip of oil seal..............................................Grease [G2-L1] 4. Set case (35) to shaft (32), then using push tool E , press fit bearing inner race portion. # When setting the case to the shaft, be extremely careful not to dam- age the oil seal. 5. Using tool F , press fit bearing (34).
# Press the bearing inner race and outer race at the same time when press fitting. Do not press only the inner race when press fitting. # After press fitting bearing, check that the case rotates smoothly. 6. Assemble gear (26), then fit holder (25) and tighten bolt (24). Mounting bolt ...................................Thread tightener [LT-2] Mounting bolt.....................................................380 ± 47N•m PC300LL-6 30-17