hyundai R60WVS Pro — 5. GEAR BOX

2. INSTRUCTIONS 2. INSTRUCTIONS The efficiency and continued operation of mechanical units depend on constant and correct maintenance and also on efficient repair work, should there be a break-down or malfunction. The instructions in this manual have been based on a complete overhaul of the unit. However, the mechanic must decide whether or not it is necessary to dismantle the individual components when only partial repair work is needed. The manual provides a quick and sure guide which, with the use of photographs and diagrams illustrating the various phases of the operations, allows to perform accurate work to take place.

Therefore all the information needed for correct disassembly, the relative check and assembly of each individual component, has been written down. In order to remove the different unit from the vehicle, the manuals provided by the vehicle manufacturer should be consulted. In describing the following operations it is presumed that the unit has already been removed from the vehicle. IMPORTANT IMPORTANT Throughout the phases of repair or maintenance work it is advisable to use proper equipment such as : Trestles or supporting benches, plastic or copper hammers, appropriate levers, extractor and specific spanners or wrenches.

So that the work is facilitated and the working surfaces and the operators themselves are protected. Before going on to disassemble the parts itis beat to thoroughly clean the unit, removing any encrusted or accumulated greases and then drain the oil through the oil-draining plug. 1) 1) 2) 2) INTRODUCTORY REMARKS INTRODUCTORY REMARKS All the disassembled mechanical units should be thoroughly cleaned with appropriate products and then restored or replaced if damage, wear, cracking or seizing have occurred.

In particular, thoroughly check the state of all moving parts (bearings, gear, crown wheel and pinion, shaft) and sealing parts (O-ring, oil shield) which are subject to major stress and wear. In any case it is a disable to replace the seals every time a component is overhauled or repaired. During assembly the sealing rings must be lubricated on the sealing edge. In the case of the crown wheel and pinion, replacement of one component requires the replacement of the other one. During assembly the prescribed pre-loading and backlash of the parts must be maintained.

3) 3) MAINTENANCE AND REPAIR MAINTENANCE AND REPAIR We have compiled these instructions for maintenance and repair in order to facilitate any such work on the DANA components differential units and change units. The drawings of any special tools required for maintenance and repair work can be bought directly from us. Spare parts can be ordered either through the vehicle manufacturer or to us directly. 4) 4) LUBRICANT SPECIFICATIONS LUBRICANT SPECIFICATIONS SAE 85W-90 (API GL-5) 7-53