hyundai R60WVS Pro — 6. STEERING VALVE

GROUP 6 STEERING VALVE 1. REMOVAL AND INSTALL 1. REMOVAL AND INSTALL 1) 1) REMOVAL REMOVAL (1) Lower the work equipment to the ground and stop the engine. (2) Operate the control levers and pedals several times to release the remaining pressure in the hydraulic piping. (3) Loosen the breather slowly to release the pressure inside the hydraulic tank. Escaping fluid under pressure can Escaping fluid under pressure can penetrate the skin causing serious penetrate the skin causing serious injury. injury. 2 3 (4) Disconnect steering line hoses (3). Loosen the hexagon bolt (2) and remove the steering valve assembly (1). · Tightening torque :

4.8 ± 0.3 kgf · m INSTALL INSTALL (5) 3 1 (34.7 ± 2.2 lbf · ft ) 3 2) 2) (1) Carry out installation in the reverse order to removal. (2) Confirm the hydraulic oil level and check the hydraulic oil leak or not. When removing the steering valve assembly, check that all the hoses have been disconnected. 7-87