Reassembly Check all mating surfaces, Replace any parts that have scratches or burrs that can cause leakage. Clean all metal parts in clean solvent. Blow dry wi th air. Do not wipe dry with cloth or paper to wel because lint or other matter can get into the hydraulic system and cause damage. Do not use grit paper or file or grind these parts. Note: Lubricate all seals with clean petroleum jelly (Vaseline). A good service policy is to replace all old seals with new seals. Do not use excessive lubricant on seals for Gerotor section. 1. Assemble spool and sleeve carefully so that spring slots line up at the same end. Rotate spool while sliding parts together. Test for free rotation.
Spool should rotate smoothly in sleeve with finger tip force applied at splined end. Align spool and sleeve by matching marks, Matching Mark Matching Mark if present. Otherwise, align spring slots in spool and sleeve and stand parts on bench Figure 10 7-94