Reassembly 2. Centering springs for low input torque units have four arched springs with two flat spacers in the center as shown in figure. Centering springs for standard input torque Low Torque Springs Standard Torque Springs units have six arched springs. Position centering springs so that the notches line up, and arched center sections are nested together. Next, with spring notches facing sleeve, insert one end of entire spring set into spring installation tool. Figure 11 3. Compress extended end of spring set and push into spool-sleeve assembly. Keep pressure on spring ends while withdrawing installation tool and pushing forward on springs at same time. 4.
Center spring set in spring slots. Seat springs down evenly and flush with upper surface of spool and sleeve 5. Insert pin through spool-sleeve assembly Figure 12 until pin is within the outside diameter of sleeve. 7-95