Reassembly 6. Lubricate seal (see parts list) before installation in seal gland bushing in housing. Use proper se al-installation tool, to make sure seal enters seal gland bushing without being cut or nicked. Do not use any seal that falls freely into counter-bore of seal gland bushing. 7. Install two bearing races and needle thrust bearing as shown in figure. Figure 13 8. Position spool-sleeve assembly so that splined end of spool enters open end of housing first. Caution : While inserting spool-sleeve assembly into housing, make sure parts do not tilt out of posi tion.
Push assembly gently into place with slight rotating action, keeping pin from moving out and getting stuck in the internal groove. Bring spool-sleeve assembly entirely within housing bore. With spool-sleeve assembly Figure 14 in this flush position, check for free rotation within housing by turning assembly with fingertip force at splined end. 7-96