hyundai R60WVS Pro — 6. STEERING VALVE

Reassembly 9. Clamp housing in vice, as shown in figure. Clamp lightly on edges of mounting area; do not over-tighten jaws. Note : Check to insure that spool and sleeve housing. are flush or slightly below 14-hole surface of Clean upper surface of housing by wiping with palm of clean hand. Clean each of the flat surfaces of parts in Gerotor section in a Figure 15 similar way just before reassembly. Do not use cloth or paper to clean surfaces. Manual Steering Valve 10. Install 77.5 ID seal in housing. Anti- Cavitation Valves 11. Install Anti-Cavit ation check valves and manual steering check valve in holes, as shown in figure. 12. Install spacer plate.

Align bolt holes in spacer plate with tapped holes in housing. Figure 16 7-97