hyundai R60WVS Pro — 6. STEERING VALVE

Reassembly 13. Rotate spool and sleeve assembly until pin is parallel with port face. Install drive, making sure drive is engaged with pin. To assure proper alignment, mark drive as shown in figure, When marking drive, note A relationship of slotted end of drive to splined end of drive. 14. Lubricate and install 77.5 ID seal in B Gerotor ring. The lubrication will hold seal in place. C 15. Align star valle ys with pin. Note parallel relationship of reference lines A,B,C and D D in figure. Align bolts holes without disengaging Gerotor star from drive. Figure 17 16. When used, install drive spacer in Gerotor star. 17. Lubricate and install 77.5 ID seal in Gerotor ring. 1 18.

Install end cap on gerotor , aligning holes. 19. Install 7 dry cap screws in end cap. Pre-tighten 6 3 screws to 17Nm, then torque screws to 35~40Nm in sequence show in figure. 20. Check for proper ti ming by turning the spool clockwise and feeling pressure in the “R” port. 4 5 21. Check the manual torque, the steering should turn freely. 2 7 Figure 18 7-98