⑪ Remove all seals, anti-extrusion rings and scraper rings from head (2), cylinder (3) and piston (5). All seals must be replaced every time the unit is disassembled. Particular attention must be paid not to damage the seats of both seals and piston slide. Assembly Assembly (2) (2) ① Grease and install the piston rod seal ring (6), rod wiper (8) and back up wash- er (7) into cylinder (3). ② Grease and install the piston rod seal ring (6), rod wiper (8) and anti-extrusion ring (7) into the head (2). ③ Fit seal (9) on the outside of the head (2). To ease installation, grease the outer surface of the piston Do not roll the seal (9). 7-126