hyundai R60WVS Pro — 7. AXLE

17 Center the piston by slowly moving it first in one direction then in the other and position it half way on the stroke, which is determined by the switching on and off of the signal lamp of the inspection device in the reversal stage. 18 Inspect jut “C” on one side of the piston and note down the size for checking later adjustments. If cylinders come without a sensor, the centering of the piston must be carried out on the basis of the maximum stroke. 19 Without moving the piston, check front and rear size at the edge of tools T6. Max. difference : 0.6-0.7 mm In order to check the rear size, rotate the bevel pinion and check that tools T6 are flat.

If necessary, adjust convergency without moving the centering of the piston and adjust the length of the steering bars (14). 20 With a half turn of screw, the front size is reduced by about 3 mm , whereas the rear one is increased by about 3 mm . 7-131