24 Perform one full steering operation until the adjusted screw leans against the arm stop. 25 As you hold the adjusted screw in position against the arm stop, adjust the screw opposite, on non-cylinder side, until it leans against the arm stop. The screws must lean against the respective arm stops all at the same time. The screws must lean against the respective arm stops all at the same time. 7-133 Requested steering angle : valueα 25˚ 27˚ 30˚ 32˚ 35˚ 36˚ 40˚ 42˚ 45˚ Steering cases versions based on max. steering angle Value W = Adjustment of the steering stop screw, steering cylinder side [mm] 35˚ max angle 55.1 51.2 45.4 41.4 35.0 45˚ max angle 57.4 47.0 44.7 35.8 31.2 24.6