⑩ Position the crown (11) on the differential carrier and lock it with screws (24) applied with loctite 270. Secure the screws using the cross-tight- ening method. ⑪ Tighten screws with a torque wrench : see table. Always use new screws to fix the crown wheel. In case the screws are not thread locking pretreated, use loctite 270. ⑫ Assemble the bearing (13). Heat the bearing to 100˚C before assem- bling. ⑬ If the bearings are replaced, insert the external thrust blocks in the middle cover and in the central body. 7-171