⑤ Using special tool T7. Partially insert the thrust block of the bearings (4) and shims (10). ⑥ Connect the tension rod to the press and move the thrust block of bearings (4) (14) into the seats. Disconnect the press and remove the tension rod. Before starting the next stage, make sure that the thrust block has been completely inserted into its seat. ⑦ Calculating pinion bearings rolling Calculating pinion bearings rolling torque torque Introduce tool T8 complete with bearings (4) and (14) into the main body (12); tighten by hand until a rolling torque is definitely obtained. ⑧ Introduce the tracer of a depth compara- tor “DDG” into either side hole of tool T8.
Reset the comparator with a preload of about 3 mm . 7-233