Note that the plated surface of rod assembly (3) is to be lifted. For this reason, do not use a wire sling and others that may damage it, but use a strong cloth belt or a rope. ⑤ Place the removed rod assembly on a wooden V-block that is set level. Cover a V-block with soft rag. 3 Wooden block (2) (2) ① Remove piston and rod cover Remove piston and rod cover Loosen set screw (22) and remove piston nut (21). Since piston nut (21) is tightened to a high torque, use a hydraulic and power wrench that utilizers a hydraulic cylinder, to remove the piston nut (21). 21 19,20 15 22 ② Remove piston assembly (15), back up ring (19), and O-ring (20). ③ Remove the rod cover from rod assembly (3).
If it is too heavy to move, move it by striking the flanged part of gland with a plastic hammer. Pull it straight with cylinder head assembly lifted with a crane. Exercise care so as not to damage the lip of Du bushing (6) and packing (8, 9, 10, 11, 12, 13, 14) by the threads of rod assembly (3). Plastic hammer Lift with a crane Pull straight 7-270