TESTING AND ADJUSTMENTS CONTROL AND ADJUSTMENT OF THE INJECTION TIMING CONTROL AND ADJUSTMENT OF THE INJECTION TIMING # Check the injection timingof the No.1 cylinderby means of the No.1 union of the injection pump. # The cylinders are numbered 1-2-3-4 counting from the flywheel side. # The spark advance notches of 0°-10°-15°-20°; are also marked on the flywheel. In order to read the interme- diate values, sub-divide the sections between the two marks into equal lengths. 1 1 - Remove the cap (1) of the flywheel casing.
RKSA0080 2 - Pass a screwdriver between the teeth and rotate the flywheel in a counter-clockwise direction (as seen from theflywheelside)until the1/4 notch of theflywheel isali- gned with the notch (2) marked inside the hole in the ca- sing. # In this position, the piston of the No. 1 cylinder is at the top dead centre (B.T.D.C.). Check that the cylinder is in a compression stroke, i.e. that both valves are closed. # Once the B.T.D.C. has been ascertained, rotate the drive shaft in a clockwise direction (seen from the flywheel side) for about 25 teeth. 2 RKSA1010 3 - Take off the clamp (3) and disconnect all the fuel deli- very tubes (4) from the injection pump (5).
4 4 - Rotate the flywheel slowly in a counter-clockwise direc- tion(seenfromtheflywheelside),checkingcarefullythe level of the fuel in the No. 1 union of the injection pump. Stop the rotation when the fuel level starts to rise. 3 5 RKSA0410 5 - Check the position of the notches at 15° and 10° that ap- pear in the hole in the casing and, in function of the po- sition, establish the true fuel injection timing. # In order to determine the degrees of intermediate fuel injection timing, sub-divide the space between 10° and 15°. # Normal fuel injection timing: 12 1° Mark 2 RKSA1021 RKSA1020 20-19 SK714-5 SK815-5