Komatsu — ADJUSTING THE STROKE OF THE ACCELERATOR CABLES

TESTING AND ADJUSTMENTS ADJUSTING THE STROKE OF THE ACCELERATOR CABLES ADJUSTING THE STROKE OF THE ACCELERATOR CABLES # Conditions for the adjustment: • Engine: stopped • Working equipment: resting on the ground • Cab: raised # If the protective sheaths need to be substituted, block the lever (or pedal) side of the sheaths in an interme- diate position before carrying out the adjustment. Min Max 1 - Place the accelerator command lever (1) in low idling position. 1 RKS01190 2 - Temporarily block the protective sheath (2) in an inter- mediate position and block the retainer (3) at approx. 1 mm from the injection pump lever (4).

2 8 3 - Put the accelerator command lever (1) into the high idling position. 7 RKSA0120 4 - Use the nuts (7) and (8) to reset the position of the injec- tion pump lever (5) to approx. 0.5 mm from the high idling adjustment screw (6). 5 - Bring the accelerator command lever back to the low idling position and check that the retainer (3) has suf- ficient clearance. 3 6 - Repeat the same procedure for the accelerator pedal cable. 4 RKSA1030 6 5 RKSA1040 20-22 SK714-5 SK815-5