Komatsu — ADJUSTMENT OF THE PPC VALVE CLEARANCES

TESTING AND ADJUSTMENTS ADJUSTMENT OF THE PPC VALVE CLEARANCES ADJUSTMENT OF THE PPC VALVE CLEARANCES The clearance of the PPC valve (hand and foot) levers is adjusted as follows. Lower the working equipment to the ground and stop the engine. Turn the ignition key to the I position and move the com- mand levers in all directions in order to release all pres- sure in the hydraulic circuits. Return the ignition key to the O (OFF) position and re- move it. Slowly loosen the oil-tank refuelling cap to eliminate re- sidual pressure. 1 - Remove cap (1). 2 - Loosen the nut (2) that retains the disc (3). 3 - Tighten the disc (3) until it makes light contact with the 4 push-rods (4).

# During this adjustment, take care not to activate any of the push-rods (4) individually. 4 - Secure this position by tightening the retaining nut (2) to the specific torque. Retaining nut: 113 15 Nm RKS 01700 20-23 SK714-5 SK815-5