Komatsu — TESTING AND ADJUSTMENT OF GEARING CHAIN TENSION

TESTING AND ADJUSTMENTS TESTING AND ADJUSTMENT OF GEARING CHAIN TENSION TESTING AND ADJUSTMENT OF GEARING CHAIN TENSION 1. Test # Test conditions: Machine: raised from the ground Working equipment: in road-driving position # Check all the wheels. A 1 - Position an appropriate indicator to correspond with the outside edge of the tire rim and make a notch “ A ” close to the indicator. RKSA0150 2 - Rotate the tire by hand in both directions and check that the displacement of the notch remains within permissi- ble limits. # Standard displacement: 2 6 mm Permissible value: 10 mm A 2 - 6 mm RKS01170 2.

Adjustment # For greater clarity, the photo opposite shows the adju- stment operations with the tire removed. It is not necessary to remove the tires for this adjust- ment. 1 A 1 - Screw a screw A (M10x50, fully threaded) into the hole provided on the frame untilit makes firmcontact with the wheel hub. 2 - Loosen the retaining screws (1) of the wheel hub until it can move. 3 - Gradually tighten the screw A until correct tension has been restored to the chain. RKSA0170 4 - Tighten the nuts (1). Nuts: 200 Nm 20-25 SK714-5 SK815-5