Komatsu — ELIMINATION OF RESIDUAL PRESSURES - PRESSURISATION OF THE TANK

TESTING AND ADJUSTMENTS ELIMINATION OF RESIDUAL PRESSURES - PRESSURISATION OF THE TANK ELIMINATION OF RESIDUAL PRESSURES - PRESSURISATION OF THE TANK 1. Elimination of pressures from the hydraulic cir- cuits. 1 - Rest the working equipment on the ground and stop the engine. 2 - Turn the ignition key to the position I and, with safety bars lower, move the command lever in all directions to release all pressure in the main hydraulic circuits and the servo-controls . 3 - Return the ignition key to the position O (OFF) and re- move it. 2. Elimination of pressure in the tank The hydraulic oil tank is of the sealed and pressurised type.

When tubes are to be removed or disconnected for con- trols or repairs, or when caps are removed, tank pres- sure must be eliminated using the following method: 1 1 - Rest the working equipment on the ground and stop the engine. 2 - Slowly loosen the oil-refuelling cap (1) in order to rele- ase residual pressure. RKSA0220 3. Pressurising the tank # This operation should be performed every time the oil- refuelling cap is moved for removal of the tubes or other hydraulic equipment. 1 - Start the engine and position the machine as in the fi- gure. 2 - Stop the engine, loosen the tank cap (1) and then close it again.

# This operation lets airinto the tankwhen the level of the remaining oil is at minimum. 3 - Start the engine and lower the working equipment to the ground. RKS01420 20-35 SK714-5 SK815-5