REMOVAL AND INSTALLATION CYLINDER HEAD REMOVAL OF THE CYLINDER HEAD \ Disconnect the negative terminal cable from the battery. 3 1 # Drain the engine coolant. 1 2 Coolant: max. 9 5 1 - Remove the water coolant pump. (For details, see «REMOVAL OF WATER COOLANT PUMP»). 4 2 - Remove filter (1) and bracket (2). RKSA0391 3 - Remove the muffler (3). (For details, see «REMOVAL OF MUFFLER»). 4 - Disconnect from head the filter support (4) with oil level rod. 5 6 5 - Remove nozzle holder (5). (For details, see «REMOVAL OF THE NOZZLE HOL- DER»). 6 - Remove the valves cover (6). 2 7 - Disconnect the pre-heater cable (7). 7 8 - Remove the rocker-arm shaft (8).
3 # Loosen the lock nuts and unscrew the valve tap- pets by 2-3 turns. RKSA0440 4 9 - Take out the rocker-arm control rods (9). 8 10 - Take out the screws (10) in the sequence indicated and remove the complete cylinder head (11). # The cylinder head gasket (12) must be substituted every time it is dismantled. 9 5 RKS01830 Exhaust side Flywheel side 7 16 18 14 12 6 4 10 1 9 3 5 11 17 13 10 15 8 2 Intake side 11 12 RKS01631 RKS01820 30-16 SK714-5 SK815-5