Komatsu — CYLINDER HEAD

REMOVAL AND INSTALLATION CYLINDER HEAD INSTALLATION OF THE CYLINDER HEAD To install, reverse the removal procedure. 1 1 - Fill up the cooling circuit. Coolant: approx. 9 2 - Start the engine to circulate the liquid through all circui- ts. Stop the engine and check the level. 3 - Pressurize the hydraulic tank and bleed air from the hydraulic circuits. (For details, see «20. CONTROLS AND ADJUSTMEN- TS»). 2 Nut: 20–23 kgm 3 Screw: 2.3–2.8 kgm 4 # Adjust valve clearance. (For details, see «20. CON- TROLS AND ADJUSTMENTS - Adjusting valve clea- rance»). 5 # Raise thecylinderhead, keeping it horizontal,and place it on the gasket without shifting anything.

Exhaust side # Lubricate the screw-threadings with engine oil. Flywheel side 18 12 10 3 1 5 7 13 15 # Tighten the screws in the sequence indicated. (See fi- gure). 14 16 8 2 6 9 4 17 11 Screw: 88.2 2.94 Nm Intake side RKS01641 30-17 SK714-5 SK815-5