Komatsu — COOLANT LIQUID PUMP

REMOVAL AND INSTALLATION COOLANT LIQUID PUMP REMOVAL OF THE COOLANT LIQUID PUMP Disconnect the cable from the negative battery terminal. 1 # Drain the engine coolant liquid. 1 Engine coolant liquid: max. 9 1 - Remove the radiator group (1). (For details, see «RE- MOVAL OF THE RADIATOR GROUP»). RKSA0450 2 - Loosen the screws (2), remove the fan (3) and the spa- cer (4). Loosen the alternator drive belt and disengage the cir- culation pump pulley. 3 2 3 - Loosen the screws (5) and remove the complete pump (6), the seal (7), and the O-ring (8). 3 4 2 INSTALLATION OF THE COOLANT LIQUID PUMP RKS01850 To install, reverse removal procedure. 1 8 1 - Fill up the coolant liquid circuit.

2 - Start the engine to circulate the liquid and oil in all cir- cuits. Stop the engine and check the levels. 6 3 - Pressurise the tank and bleed the air from all circuits. (For details, see «20. TESTING AND ADJUSTMEN- TS»). 7 5 2 RKS01840 # Adjust the belt tension. (For details, see «20. TESTING AND ADJUSTMENTS – Testing and adjustment of the fan-belt »). Fan screws: 10–1.2 kgm 3 # A new seal (7) and new O-ring (8) must be fitted each time the pump is removed. Pump screws: 2.3–2.9 kgm 30-18 SK714-5 SK815-5