REMOVAL AND INSTALLATION CAB 7 - Disconnect the accelerator command lever cable (12) from the engine (11). 11 2 12 RKSA0131 8 - Connect the cab (13) to some hoisting tackle. 13 RKSA0270 9 - Remove the safety cotter pins (14) and the washers (15). 10 - Push the cab (13) slightly towards its “at rest” position to relieve the strain on the safety cables (16), and discon- nect the cables from the pins (17). 17 18 17 16 16 Apply a slight tension to the chains of the hoisting tackletopreventthecabfromswingingaboutunex- pectedly. 14 15 14 15 11 - Tilt the cab (13) slowly until the distance between the centres of the dumper fixing hooks is 1100 mm..
# The distance of 1100 mm corresponds to the ma- ximum stretch of the dumper hooks. RKSA0281 12 - Remove the pins (17) from the dumper fixing hooks (18). 21 13 - Loosen the nuts (19) and remove the screws (20) and washers (21). 14 - Remove the complete cab (13). 13 20 19 RKSA0560 30-23 SK714-5 SK815-5