Komatsu — CONTROL VALVE

REMOVAL AND INSTALLATION CONTROL VALVE REMOVAL OF THE CONTROL VALVE Fully raise the working equipment and tilt the cab. (For details, see «TILTING THE CAB»). 1 Release residual pressures from all circuits and from the tank. (For details, see «20. TESTING AND ADJU- STMENTS»). 2 2 # Drain the hydraulic oil. Hydraulic oil: max.. 39 1 - Disconnect from the control valve (1) the servo-control pipes (2),the delivery pipes to the actuators, and the de- livery and return pipes (3). # Markthetubes toavoid exchangingthem duringre- assembly. 3 RKSA0680 2 - Loosen the three screws (4) and remove the control val- ve (1). 1 4 1 Control valve: max.

21.5 kg RKS 01880 INSTALLATION OF THE CONTROL VALVE # To install, reverse removal procedure. 1 Control valve screws: 35 Nm 1 - Fill the hydraulic oil tank up to maximum level. Hydraulic oil: max. 39 2 - Start the engine at low idling to circulate the oil throu- ghout the system. 3 - Pressurise the tank and bleed the air from all circuits. (For details, see «20. TESTING AND ADJUSTMEN- TS»). 30-33 SK714-5 SK815-5