3) flatness Measure flatness of the intake/exhaust manifolds fitting surfaces on the cylinder head using a straight edge and a feeler gauge. 4) Hydraulic test Hydraulic test method for the cylinder head is same as that for cylinder block. 3.2.3. Valve and valve guide 1) Valve Clean the valves with clean diesel oil, then inspect them as follows: Valve stem outer diameter Measure the valve stem outer diameter at 3 positions. (top, middle, and bottom) If the amount of wear is beyond the limit, replace the valve. End of stem EFM2036I Valve seat contacting faces Check the valve seat contacting faces for scratches or wear, and correct the faces with grinding paper as necessary.
Replace if severely damaged. - 42 - Standard Limit 0.05 mm 0.2 mm Dimension Description Standard Limit Intake valve stem 10.950 ~ 10.970 mm 10.87 mm Exhaust valve stem 10.935 ~ 10.955 mm 10.84 mm