Connecting rod bearing clearance Install the connecting rod bearing in the connecting rod bearing cap, tighten the connecting rod cap bolts to the specified torque, then measure the inside diame- ter. EAMD060I If the clearance deviates from the specified range, have the crankshaft journals and pins ground and install undersize bearings. 3) Bearing spread and crush Inspection Check to see that the bearing requires a considerable amount of finger pressure at reassembly operation. O A O B Spread = O A - O B EDM2047I - 52 - Torque 28 kg•m Standard Dia.
83.02~ 83.092 mm Compare the two values obtained through measurement of connecting rod bearing inside diameter with the outside diameters of crankshaft pins to determine the oil clearance. Standard Limit 0.049 ~ 0.119 mm 0.20 mm