3) Crankshaft run-out Support the crankshaft on V blocks. Turn the crankshaft with a dial indicator placed on the surface plate and take the amount of crankshaft run-out. 3.2.7. Crank shaft bearing and connection rod bearing 1) Visual check Visually check the crankshaft bearing and connecting rod bearing for scores, uneven wear or damage. 2) Oil clearance between crankshaft and bearing. Main bearing clearance Install the main bearing in the cylinder block, tighten the bearing cap to speci- fied torque, then measure the inside diameter. - 51 - Standard Limit 0.05 mm 0.1 mm Torque 30 kg•m Standard Dia.
96.06~ 96.108 mm Compare the two values obtained through measurement of main bearing inside diameter with the outside diame ters of crankshaft journals to determine the oil clearance. Standard Limit 0.072 ~ 0.142 mm 0.25 mm