2) Wear With an outside micrometer measure the diameter of the crankshaft journals and pins in the directions as shown, and compare the measured values to deter- mine the amount of wear. If the amount of wear is beyond the limit, have the crankshaft ground and install undersize bearings. However, if the amount of wear is within the limit, you can correct the wear using an oil stone or oiled grinding paper of fine grain size.
(Be sure to use grinding paper which has been immersed in oil.) A B B Journal diameter B B Pin diameter A EFM2047I * Undersize bearings available Standard 0.25 (Inside diameter is 0.25 mm lesser than the standard size.) 0.50 (Inside diameter is 0.50 mm lesser than the standard size.) 0.75 (Inside diameter is 0.75 mm lesser than the standard size.) 1.00 (Inside diameter is 1.00 mm lesser than the standard size.) Undersize bearings are available in 4 different sizes as indicated above, and the crankshaft can be reground to the above sizes. Note : When regrinding the crankshaft as described below, the fillet sec- " R " tion ‘R’ should be finished cor- rectly.
Avoid sharp corners or " R " insufficient fillet. * Standard values of ‘R’ 1 Crankshaft Pin ‘R’: 4.5 " R " " R " " R " Crankshaft journal ‘R’: 4 2 EFM2048I - 50 - Standard Limit 95.966 ~ 95.988 mm 94.966 mm 82.966 ~ 82.988 mm 81.966 mm