3.2.8. Piston 1) Visual check Visually check the pistons for cracks, scuff or wear, paying particular attention to the ring groove. 2) Clearance between the piston and cylinder liner With an outside micrometer, measure the piston outside diameter at a point 18mm away from the lower end of pis- ton skirt in a direction at a right angle to the piston pin hole. Using a cylinder bore gauge, measure cylinder liner inside diameter at 3 points (cylinder top ring contacting face, middle, and oil ring contacting face on BDC) in a direction at an angle of 45(. Take the mean value with the largest and smallest values excepted.
- 54 - Standard 122.854 ~ 122.886 mm Standard Limit 123 ~ 123.023 mm 123.223 mm The clearance is computed by sub- tracting the piston outside diameter from the cylinder liner inside diameter. Replace either piston or cylinder liner, whichever damaged more, if the clear- ance is beyond the specified limit. Clearance between piston and liner Standard 0.114 ~ 0.169 mm