3.2.9. Piston rings 1) Visual check Replace the piston rings with new ones if detected worn or broken when the engine is overhauled. 2) Piston ring gap Insert the piston ring into the upper por- tion of the cylinder liner bore so that it is held at a right angle to the cylinder liner wall. - 55 - Measure the piston ring gap with a feel- er gauge. Standard Limit Top ring 0.30 ~ 0.45 mm 1.5 mm 2nd ring 0.35 ~ 0.50 mm 1.5 mm Oil ring 0.30 ~ 0.50 mm 1.5 mm Replace piston rings with new ones if the gap is beyond the limit ston ring side clearance Fit the compression ring and oil ring in the piston ring groove.
Feeler gauge With a feeler gauge, measure side clearance of each ring, and replace either the ring or piston if the measured value is beyond the specified limit. Standard Limit Top ring - EA4M2007 2nd ring 0.07 ~ 0.102 mm 0.15 mm Oil ring 0.05 ~ 0.085 mm 0.15 mm Standard Limit Top ring - 2nd ring 0.07 ~ 0.102 mm 0.15 mm Oil ring 0.05 ~ 0.085 mm 0.15 mm Standard Limit Top ring 0.30 ~ 0.45 mm 1.5 mm 2nd ring 0.35 ~ 0.50 mm 1.5 mm Oil ring 0.30 ~ 0.50 mm 1.5 mm